Switching between LUTs
Posted: October 20th, 2011, 12:08 pm
I borrowed XRite i1 profiler and made two monitor profiles: one with D65 and the other 'Native', which I understand will be the temperature of backlight, likely much higher than 6500K. Each produces corresponding LUT. At the end of profiling, the i1 also loads the LUT matching the last profile, and makes this profile Windows Default (which, I take it, PWP ignores since it allows to specify the monitor profile from within the programme). But it still needs LUTs, right? Otherwise the profiles are not valid.
I can switch the Monitor profile in PWP, but how do I switch/load the proper LUT corresponding to the profile?
Cheers!
I can switch the Monitor profile in PWP, but how do I switch/load the proper LUT corresponding to the profile?
Cheers!