Page 1 of 1

Window Size Layout

Posted: May 2nd, 2013, 2:16 pm
by Dieter Mayr
I have the font size set to 117% for my 23 inch monitor. The unit of measurement I have set to mm.
With the default size of Layout's main window and a page size of about DIN A4 (210 x 297mm) the numbers at the horizontal ruler are impossible to read when it goes over 100 mm.
Layout_Fontsize.png
Layout_Fontsize.png (4.2 KiB) Viewed 3272 times
The size of the window is roughly 460 x 310 pixel.
Resizing the window bigger solves this of course, and the bigger size is saved throughout a session, but when closing PWP and restarting it is at it's default size again.
Would it be possible to save the size of the window or to make it bigger related to the font size ?

Re: Window Size Layout

Posted: May 2nd, 2013, 2:59 pm
by jsachs
For the next release, I increased the initial window size and changed the rulers to use a smaller font.